Offshoreonly.com - What would the OD of this #8 fitting be?

Offshoreonly.com (https://www.offshoreonly.com/forums/)

- General Q & A (https://www.offshoreonly.com/forums/general-q-20/)

- - What would the OD of this #8 fitting be? (https://www.offshoreonly.com/forums/general-q/100275-what-would-od-8-fitting.html)

BadDog

04-09-2005 06:31 AM

What would the OD of this #8 fitting be?

Any idea what the OD of this fitting would be? I want to install it below the low point of the water feeds on my Lightning Headers and Y them into to. This way I can remove a cap on the outside of the boat to drain the headers at the end of the day.

http://www.eddiemarine.com/cart/deta...&CategoryID=97

Perhaps there is a better thru-hull to use?

dana marine products

04-09-2005 07:40 AM

Re: What would the OD of this #8 fitting be?

-8 AN is 3/4" diameter.

All times are GMT -5. The time now is 02:33 AM.