cc of small oval part heads
what is the cc's of the small oval port heads? I though they were 110, but I have a book that says there 118. The book I have is Big Block chevy marine performance. HPBooks by Dennis Moore. I have seen on line were there suppose to have 110 cc's. somebody wrong??
Thanks Dan |
Re: cc of small oval part heads
They are mostly all 119 from what Ive measured. Tell us what the casting number is and we can look it up.
|
Re: cc of small oval part heads
Originally Posted by danielthelen
what is the cc's of the small oval port heads? I though they were 110, but I have a book that says there 118. The book I have is Big Block chevy marine performance. HPBooks by Dennis Moore. I have seen on line were there suppose to have 110 cc's. somebody wrong??
Thanks Dan Go get a Chevy High Performance catalog from GM . You will see what I mean from peanut port to oval port. Peanut ports are used in passenger vehilces. Oval port are truck engines |
Re: cc of small oval part heads
L29 Vortecs are 100cc's, just measured them!
|
Re: cc of small oval part heads
Opps, Im old, my reply was refering to Mark 4 oval ports, peanuts, 781's 049's. I know there are lots of others with smaller chambers that were older closed or semi closed chamber heads. The newer gen 5 and 5 vortecs are smaller as Andy stated. Really need the casting number to be sure.
|
Re: cc of small oval part heads
Edelbrock makes a large oval port aluminum with 110cc.
There are old closed chambered heads out there that are 105-110cc. Most heads used on Gen IV and Gen V marine engines have 118cc. Gen VI magnum engines have 118. Gen VI L-29 454s have the heart shaped Vortecs and measure around 100cc... I have an extra set of Vortec heads if someone would like them... |
Re: cc of small oval part heads
I don't have the casting number's, I did at one time and had the heads off. They looked like open chamber heads. the year of the engine is 1987.
|
Re: cc of small oval part heads
They are likely peanut port heads then. 119 cc.
|
Re: cc of small oval part heads
Looks like I can just bolt my 781 and 049 heads on then. All the ports cc out at 118 to 120. I was thinking about useing a steel gasket to get the quench down and increase compression ratio a bit. Looks like about 5 cc's Sound good?
|
Re: cc of small oval part heads
have you tried http:// www. mortec.com
|
All times are GMT -5. The time now is 11:44 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.