Carnage.... #1 u joint and outer belhousing
 

:evilb: OK so i splashed again today and i blew the carrier that holds the two ujoints on the input shaft. the joint surfaces were good but the carrier had a saddle stretch and break. i was not going fast and i would say i have a total of 3 min at 5 k or above. at 80 mph. So...... it must have been a weak part. I inspected it but it did not magnaflux it. The only real problem is it took out the outer bell housing as well. I am ordering a NEW shaft and joint assembly. I do not want one that someone has been jumping with. I have heard stories about the hp gimbal assembly but i do not think i am going that route. Dose any one in the Midwest have a good used outer bravo bellhousing? It is supposed to be nice here on Sunday so i would like to have it on the water by then but i suppose it will not happen.

Please email me at [email protected]

If i do not get any feedback by tomorrow noon i will probably just order new. thanks for any and all help in this department.

Re: Carnage.... #1 u joint and outer belhousing
 

Call Eric @ Maveric Marine, He's got a few good used ones on the shelf. 818 989 4445. they are in California.Tell him Jake sent ya

Re: Carnage.... #1 u joint and outer belhousing
 

Bump...... i would prefer to get a used belhosing. Any one with a decent used one laying around?

Re: Carnage.... #1 u joint and outer belhousing
 

Bump bump Bump yes this is a post whore thread.....

Re: Carnage.... #1 u joint and outer belhousing
 

call Bam ..... 954 545 8681 (phone)

Re: Carnage.... #1 u joint and outer belhousing
 

Fox River Performance Marine will have them. They are in Oshkosh.

Re: Carnage.... #1 u joint and outer belhousing
 

Yep, that's where i got it from

Thanx