What's this thing in my bilge?
#1
Registered
Thread Starter
Join Date: Oct 2000
Location: Lombard, Il
Posts: 650
Likes: 0
Received 0 Likes
on
0 Posts
What's this thing in my bilge?
What is this little puck in my bilge?
There are two of them in the forward section of the bilge. same spot on both sides. Looks like a #10 screw coming out of it.
There is no marking or any indactor in this area on the outside of the boat.
What is it?
There are two of them in the forward section of the bilge. same spot on both sides. Looks like a #10 screw coming out of it.
There is no marking or any indactor in this area on the outside of the boat.
What is it?
Last edited by Zanie; 05-16-2005 at 07:24 AM.
#2
Re: What's this thing in my bilge?
it looks like some one left a grinding disk and covered it with resin
not sure what the heck that is. I had to go check my excalibur to see if I had that there but I dont . its hard to say what previous owners had done to boats. I know I found a few odd things in the bilge.
good luck
Brad
not sure what the heck that is. I had to go check my excalibur to see if I had that there but I dont . its hard to say what previous owners had done to boats. I know I found a few odd things in the bilge.
good luck
Brad
#6
Re: What's this thing in my bilge?
Originally Posted by robyw1
maybe a thru-hull transducer for a depth gauge? then again i don't know why there would be two.
Roby
Roby
But one of mine hangs off of the transom.
#8
VIP Member
iTrader: (1)
Re: What's this thing in my bilge?
Could be a plug for a water intake port.
__________________
Want your ECU tuned right?? Call Mark at Precision www.pmefi.com
Want your ECU tuned right?? Call Mark at Precision www.pmefi.com
#9
Registered
Thread Starter
Join Date: Oct 2000
Location: Lombard, Il
Posts: 650
Likes: 0
Received 0 Likes
on
0 Posts
Re: What's this thing in my bilge?
They have been in there since the boat left the factory. The factory gray bilge paint was covering them when I got the boat.
I'm looking for a place to install a shoot thru transducer so I'll need to remove coring to do that. I was kinda hoping I could just cut one of these out to do it.
I was hoping somebody might have seen these before.
Thanks!
DS
I'm looking for a place to install a shoot thru transducer so I'll need to remove coring to do that. I was kinda hoping I could just cut one of these out to do it.
I was hoping somebody might have seen these before.
Thanks!
DS