Hemi Project finished at Mesa
 

Guys this is the Road Runner I posted last month and here it is finished tuned installed and ready for delivery yesterday. Steeve called me and asked me if I would deliver it and I told him he had to pick it up so he could drive it before I would give it back. He came to pick it up about 11 in the morning we drove to the end of the block and he stood in it when he got to 3 rd gear he looked over at me and didn't say anything the smile on his face was priceless this is a guy who's not easy to please he owns and runs three strip bars . When he brought me back to the shop the only thing he said was I can't thank you enough it was everything I wanted .

Re: Hemi Project finished at Mesa
 

Here are a couple of pics on the dyno the week before install . We also rewired the engine compartment and custom fab an aluminum radiator to cool the elephant and 1/2 fuel lines from Straight Line .

Re: Hemi Project finished at Mesa
 

Bad Azz :D :D :D

Re: Hemi Project finished at Mesa
 

well laz wtf, what were the dyno numbers bro?

Re: Hemi Project finished at Mesa
 

That looks sweet, what kind of numbers did it pull on the dyno???

Re: Hemi Project finished at Mesa
 

RAT they told me at Mopar it wouldn't make more than 425hp and 420 ft lbs so being the easy to satisfy guy that I am I used a different carb then the one they recommend I used a 750 cfm vac sec and modified to 4 corner idle and did some work on the sec metering plate changed some sec springs and plugged up the vac advance in the distributor moved the weights around and made 475 hp @ 5750 rpm and 488ft lbs at 3700 rpm the kicker was I pulled it from 3000 rpm to 6000 and the torque started at 445 and ended at 445 ft lbs you can roll in the throttle anywhere you want 1st-3rd and light the tires all the way to 6000 rpm it's awesome.

Re: Hemi Project finished at Mesa
 

You had better put a boat hitch on that puppy uf you are going to show it on this site. :evilb:
Just kidding.
It looks great!! Nice job. Great numbers too.

Re: Hemi Project finished at Mesa
 

I figured with the torque it made he could pull his boat with it.