496 CNC ed heads by Tyler Crocket
What a nice piece ,flow sheets show 28.5 % increase.My own measurement show 24.5% increase in exhaust ports and valves are 100 thousands larger with smaller shafts . My mehcanic was real pleased .They do make stock heads look like a toy.there being installed under my whipples as we speek on top of a monster cam and other good stuff hope to see 750 825 hp the old motors made 640 hp 7lbs boost no troubles 354 hrs old long blocks still in tact 150 compression on one 160 on the other
|
Re: 496 CNC ed heads by Tyler Crocket
How much were the heads?
|
Re: 496 CNC ed heads by Tyler Crocket
Got any moore info on your motor. What bore etc. I am running 750 HP on 5lbs boost bore is 30 over. I'm sure i would see at least 800hp with 7lbs boost. If you have any pics please post.
|
Re: 496 CNC ed heads by Tyler Crocket
Don't leave us hangin, were always looking for new and fresh ideas for 496 power!!! :rolleyes:
|
Re: 496 CNC ed heads by Tyler Crocket
Bobby check out the Pokerruns post........their talking about you again. Under PC poker runs. Oh yeah and for all you on here don't listen to him I beat him with my 68mph boat again this year.......... :D
|
Re: 496 CNC ed heads by Tyler Crocket
Are we talking about a 496MAG or older style 496 big block?
Thanks |
Re: 496 CNC ed heads by Tyler Crocket
The 496,s are new style 30 over cam specked by Whipple ecu done by Whipple.Mycruise speed dropped 500 rpm,s and I was at my old top end at 5/8 trottle. My8lb pulley now only makes 5lbs boost . Iwant to run 8lbs Ill know what seize I need by mon.The heads flow real good. The motors run cooler now. Ill post stats on mon.FEELfree to call 4127810881 Bob
|
Re: 496 CNC ed heads by Tyler Crocket
You said your shortblock is stock? How are your hypereutectic pistons holding up?
|
Re: 496 CNC ed heads by Tyler Crocket
I didn't see a price for the port/polish and valve work on their website? Could you PM how much you paid for just the headwork? Thansk!
|
Re: 496 CNC ed heads by Tyler Crocket
Me too on the CNC work, Thanks
Curious also about your short block. Could you maybe recap your setup i.e. crank, rods and pistons. Dave |
All times are GMT -5. The time now is 01:46 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.