Re: offshore water pickup and drag
 

I got it from mike at mc engineering. He makes a lot of parts for merc and the offshore race teams. He is in gainsville, he had me make a template out of cardboard and mail it to him so I could use all my existing transom holes. You will also need to give him the measure in degrees of your transom angle. Here is his email [email protected] tell him you saw the one he made for phil ratcliffe his phone number is 352-395-6582 he does not answer the phone often so leave amessage. Good luck, ratman it was around 540 bucks unpolished, i think he gets 650 for a polished one, and they look beautiful

Re: offshore water pickup and drag
 

Is a water pressure gauge needed if your using a circulating pump with an offshore p/u?

Re: offshore water pickup and drag
 

YES!