Re: Installing hydraulic steering.
 

Nice job and thanks for sharing :cool: .
Let us know after your sea trial how it all works out. We are considering a similar project in the near future.

Re: Installing hydraulic steering.
 

Is it me , or does the bottom pic show the starboard ram bolted right at the bottom of the boat and the next pic up shows it bolted about 6 inches up from the bottom :confused: :confused:

Re: Installing hydraulic steering.
 

Keep looking down...you will see the rest of the boat...It got me to for a couple minutes ! :D

It's a shadow from the K-plane

Re: Installing hydraulic steering.
 

With full hydraulic, the steering wheel may not stay centered as time goes buy and fluid "slips" by the internal seals, so straight ahead may be with the wheel slightly turned one way or the other. This is the curse of full hydraulic steering. Without the hard cable link to the pilot valve, "center" can drift somewhat. That is why most full hydraulic wheels are symmetrical three spokes. This is not a problem just a little "issue" so don't be surprised if it happens. Most just drive the boat and don't look at the position of the wheel until stopped and then straighten up the wheel with the engine(s) off.

Re: Installing hydraulic steering.
 

DOH!!!! You're right , I'm stupid :rolleyes:

Sure did look like the bottom of the boat.