Drive Spacers Anyone?
 

Anyone have a pair of 1" Bravo I drive spacers (complete) for sale? I have been thinking about trying a set.

Thanks,

Tom

Re: Drive Spacers Anyone?
 

Docmanrich37 has a set of 1 1/2 spacers that he does not need.
shoot him a pm

Re: Drive Spacers Anyone?
 

Thanks Will.Yes i have 2 seys of complete 1 1/2" spacer .email me if interested.they are in the swap shop.

Re: Drive Spacers Anyone?
 

Anyone go a set of 1" spacers??

Re: Drive Spacers Anyone?
 

Pair of 1" spacers in stock.

TRICK MARINE
866 921 4553

Re: Drive Spacers Anyone?
 

i have a set of 1in spacers if you need them give me a call (917-682-2620 rob

Re: Drive Spacers Anyone?
 

Just curious when adding 1" spacers, will 1" longer vertical shaft be needed also?

Re: Drive Spacers Anyone?
 

No.....they come with a splined sleave.

Re: Drive Spacers Anyone?
 

That's good to hear in case my 2" shorties are too short. What's the difficulty of install on the spacers?

Re: Drive Spacers Anyone?
 

I'm in the process of installing 1" spacers on my Bravo's. Looks like a fairly simple process, especially with a drive stand.

However, what is the trick (or the best way) to remove the old studs ?? Double nutting or with heat ?? I know this needs to be done correctly.

Can someone advise me on this?

Thanks,

Re: Drive Spacers Anyone?
 

Stud remover.very simple when you have one.double nut is cheaper to do if you don't have a remover.just did some last week.hope this helps.

Re: Drive Spacers Anyone?
 

I have been in the process all afternoon installing a 1/2" spacer. I looks straight forward. I have a stud remover tool that I got from Sears. The one part that I was worred about was pulling the old studs out. That part went without a hitch. Old studs came out. Took Blue locktite & installed new studs. Installed o rings & went to reinstall lower. I have a bravo upper with a Imco 2" shortie lower. I could get the lower on except for about the last 1/2 or 3/4". After fighting trying to get the lower on for about 2 hrs I went to remove one stud to see if it would go thru the imco lower. It would not. I then tried to see if the stud would go thru the upper it would not. The studs have a thick middle sections and that will not go thru. I looked at drilling out both the upper and lower but do not have the correct size drill bit. I think it may be easier to go and get new studs.