How long to wait on 5200 before use.
 

I need to know how long I have to wait to introduce 5200 to water after using it. Does it need a certain amount of set time prior to use? Can I just wait a couple of hours and run with it?

Buck

Re: How long to wait on 5200 before use.
 

I think your good to go. If Im not mistaken, it cures with water. But dont take my word on it :rolleyes:

Re: How long to wait on 5200 before use.
 

if I remember fast cure is 24 hours slow cure is 7 days ....

Re: How long to wait on 5200 before use.
 

You will probably be ok, but I always prefer to give 5200 a couple days if below the waterline as a sealer. Above the waterline as a bedding compound, (hatch etc.) a few hours is probably sufficient.

Re: How long to wait on 5200 before use.
 

It depends, there is a 5200 normal cure, which sets up in 24 hours and cures in 7 days, or a 5200 fast cure which is a much better choice, but harder to find. The label pretty much spells it out. If you don't give it enough time, it will ooze out, run, and drip.

Re: How long to wait on 5200 before use.
 

Did you buy a boat? What the hell are you doing? :D

Re: How long to wait on 5200 before use.
 

If you want to put it in the water right away I believe you want 4200. Boat Life is also good it will cure if wet.

Re: How long to wait on 5200 before use.
 

if you used it to glue your wig to your head I would wait at least two hours before swimming, and if you glued your strapon back together you dont need to wait, short stroking it wont break the glue.