Old Bravo lower W/ new Bravo upper?
#21
Platinum Member
Platinum Member
iTrader: (1)
Re: Old Bravo lower W/ new Bravo upper?
Here you go,VIP has 1/4 drill bits 12" and 18" looooong,Smittyhttp://www.valleyindprod.com/shopping/index.php?cPath=161_180
#22
Platinum Member
Platinum Member
iTrader: (1)
Re: Old Bravo lower W/ new Bravo upper?
http://www.valleyindprod.com/shoppin...?cPath=161_180
browse as a visitor,go to special drills, they have a 1-800# to order but find your part# first because you'll probably be talking to a operator or order taker,Smitty
browse as a visitor,go to special drills, they have a 1-800# to order but find your part# first because you'll probably be talking to a operator or order taker,Smitty
Last edited by articfriends; 07-11-2006 at 01:42 AM.
#25
Registered
Join Date: Mar 2009
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
new bravo 1 lower replacing 1990 bravo lower
So if i understand everybody correctly all i have to do to use a 2000 bravo one lower on a 1990 bravo one upper is plug the oil hole on the new lower? What do i use to plug the hole is my next question?
#26
Charter Member #601
Charter Member
If there is no hole in the upper housing then just tap the hole i the lower and install a small stainless set screw with a hex socket (?) that you would screw in with and allen wrench.. Use some red locktite on it and make sure it is flush with the top of the lower case. The smaller the set screw the better, in case you want to ever use it on a newer upper..
Hope this helps.
Dick
Hope this helps.
Dick
#28
Registered
Join Date: Nov 2001
Location: Pennsylvania
Posts: 3,385
Likes: 0
Received 0 Likes
on
0 Posts
I am doing the same this week to two drives; old uppers w/ newer lowers. It appears the thread size that would fit without drilling is 5/16-18. That's what I am going to put in anyway. Now I have to find of SS set screws, that should be fun