How do you pull engine with TRS drive / BW tranny ?
 

I need to pull my port engine. I`ve got TRS drives / Borg-Warner transmissions.
I`ve pulled engines with Bravo drives, so I already know the basics. But how do you pull engine if it has a tranny behind it ?
Do I need to pull eng / trans as a unit or what ?

TIA

Re: How do you pull engine with TRS drive / BW tranny ?
 

I Have A #3 And Velvet Drive I Just Unbolt It Straight From The Engine, And Leave The Trans Bell Housing Right In The Boat

Re: How do you pull engine with TRS drive / BW tranny ?
 

We just pulled a HP800/SSM III yesterday. We left the tranny on the motor. Just make sure you have enough room in front of the engine. You need to pull the engine forward and up.
Drive removed of course. Took about 2h. from start t finish.

Re: How do you pull engine with TRS drive / BW tranny ?
 

I don`t have much room in front of engine. Looks easier to leave bellhousing attached to trans.
So --- How do you line up engine upon reassembly ?
With this method, do you have to pull drive ?

Re: How do you pull engine with TRS drive / BW tranny ?
 

I Dont Pull My Drive, Its Pretty Easy Just A Little Wiggling And It Should Pop Back In.......

Re: How do you pull engine with TRS drive / BW tranny ?
 

You will need to re align it after putting it together, so you will need to pull the drive.

I am no pro at this so... :drink:

Re: How do you pull engine with TRS drive / BW tranny ?
 

If you separate engine block from bell-housing and leave the bell-housing/tranny in boat, there should be no reason to re-align on re-assembly. (and of course, this way you don't mess with the outdrive at all) --- Jer

Re: How do you pull engine with TRS drive / BW tranny ?
 

Why don`t you need to re-align? the tranny is mounted on to "ears" on the inner transom and can be moved up or down when the engine is removed. If the engine is tilting more up or down when reinstaling then the alignment will be off, wouldn`t it?

Just curious, newer put one back inn. First time this time :D

Re: How do you pull engine with TRS drive / BW tranny ?
 

This makes sense to me. It almost sounds too easy.

I`m off to the shop --- engine should be sitting on the floor in a little while.
Then pull the camshaft...

Re: How do you pull engine with TRS drive / BW tranny ?
 

AS LONG AS THE ENGINE IS GETTING BOLTED BACK IN THE SAME PLACE IE THE BRACKET IT IS IMPOSSIBLE FOR IT TO BE MIS ALIGHNED..............IT IS GOING BACK IN THE SAME EXACT POSITION//////////