Re: 502 MPI - ASM lower intake versus stock
 

Motor is a 540,merlin 2 block,afr cnc 315's,hyd roller cam with morel lifters. Cam is just over 600 lift and mid 230's at .050 duration. Bob madera (AKA rmbuilder)585-654-8583 spec'd out the cam and had it custom ground for me for same price summit sells them for. I wanted to make 850 hp minimum and have good idle,he told me it should make 950 hp and have at least 10" of vacuum at idle from his calculations,he was dead on. I'm seeing 10-11 psi of boost at 5900 rpm's,I run 92-93 octane gas. Motor has 100 hours on it with no meltdowns,Smitty

Re: 502 MPI - ASM lower intake versus stock
 

Smitty - I'll need that other t-body you have (IAC horn one) to see if it can be modded w/ my plate and such. I can't tell by looking at my set up without having that one on hand.

Send me an e-mail and I'll give you shipping address.

Sorry for taking so long - I thought I was waiting for you but after reading this post and talking to RMBuilder this AM I remember it now as you where waiting for me.

I'm getting old. Sorry.

Re: 502 MPI - ASM lower intake versus stock
 

SB-aka cfm,all this time I didn't realize you were one and the same :D ,I figured whoever you were you knew your stuff though,Smitty