700 sci
 

Will the new 700sci bolt up to a regular bravo xr or does it have to mount up to that new nxi outdrive only?

Re: 700 sci
 

as long as there no sensors or other stuff from the belhousing back .I would think if you used every thing from a bravo bellhousing back it would bolt up.I am sure its a aftermarket block like dart

Re: 700 sci
 

it says that it is designed off the same same motor as the 525. The only reason I was wondering is that they will only sell that new drive with that motor. I was wondering if I could pull my 525 and put in the new 700sci or the 1050sci.

Re: 700 sci
 

I didn't think a bravo XR would take much over the 700SCI horses?

Re: 700 sci
 

I was just wondering if they would bolt up or did it have to match up to the new drive system.

Re: 700 sci
 

it runs a trans like a #6 DRIVE(between motor and drivethere is some speical setup on water to warrenty motors

Re: 700 sci
 

In order to get one you would have to find a Merc Dealer to split up the combo for you. But that may get them in trouble with Merc.

Re: 700 sci
 

Not sure why you wouldn't want to install the drive too? You can leave the engine location right where you have it, drill and cut the transom, and install the drive. I think the propshaft ends up a little over 1" higher than a shorty sportmaster.
I guess there are always other things to think about. Going even higher (mounts, and possibly some consequences on the cutout). Steering, you will need a helm at a minimum. I am sure there are always some other minor problems too.