Offshoreonly.com

Offshoreonly.com (https://www.offshoreonly.com/forums/)
-   General Q & A (https://www.offshoreonly.com/forums/general-q-20/)
-   -   mefi tuning finally available to everyone-CHEAP (https://www.offshoreonly.com/forums/general-q/157998-mefi-tuning-finally-available-everyone-cheap.html)

MEFIburn 06-21-2007 10:30 AM

Thanks Dave, it was nice meeting with you also. For those in Socal needing any work to their EFI powered boat, Dave is the man to see. He has a very nice setup and incredibly good diagnostic tools.

ls1nova 06-21-2007 08:08 PM

I'll let you guys know how it works out.

Frank

US1 Fountain 12-04-2007 11:24 PM

Has anyone used the Scan only version? Not the scan and tune version. The $200 price looks like a good alternative from the much higher $$ Diacom.

How does it compare to the Merc/Rinda scan tools?

Just looking for something to read all the numbers for trouble shooting, not reprogramming.

JasonSmith 12-06-2007 10:18 AM

We used this on my boat. We were BETA testers for the development. Works good.

US1 Fountain 12-06-2007 04:37 PM

Whats BETA?
So it is basically the same as the Diacom as far as info shown on the PC?

Griswald 12-06-2007 06:22 PM


Originally Posted by US1 Fountain
Has anyone used the Scan only version? Not the scan and tune version. The $200 price looks like a good alternative from the much higher $$ Diacom.

How does it compare to the Merc/Rinda scan tools?

Just looking for something to read all the numbers for trouble shooting, not reprogramming.


I bought this software for MEFI 1 during the summer and gave up trying to get it to work. I would get data, but it was always erratic. i.e. timing at idle would read anywhere from 13* to 2000* just moving around like crazy. I talked to Bob and he suggested I play with the data stream speeds and all it did was get worse. I gave up calling him and gave up on the software. I've wasted $200 on less!

JasonSmith 12-06-2007 07:11 PM

BETA is like VHS, only smaller & less avalibity.
BETA is actually a term used for stuff still in development/fine tuning.

US1 Fountain 12-06-2007 07:38 PM

Alrighty. Thanks guys.

Going to look for a used Diacom then, or a Scan tool.

MEFIburn 12-07-2007 12:45 PM

In a small number of instances the electrical noise in the engine compartment will cause some data samples to drop out while scanning, causing the values to fluctuate. The samples that are there are valid and show the correct data. Occasional scanning data packet lose is expected, but in some cases the data drop outs are frequent enough where the displays will have values bouncing around, like in Griswald's, making it distracting to read. We now have a cable that has much higher RF electrical noise immunity. Griswald, if you would like to send us your cable we will send you a new one. We are here to provide useable solutions, and this scanning package, for less than $200, shows you every parameter from the MEFI controller with detailed logging capability.

Griswald 12-07-2007 12:56 PM

I will take you up on that offer and see if it helps me. Be on the lookout for my email.

Clark Bird
Austin, TX


All times are GMT -5. The time now is 04:28 PM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.