pcv do they help
 

engine pushing dipstick out , builder says run pcv will this help or not 10.1 to 1 600 cuber says put to gether loose , all forged motor make sense , notic e steam out breathers now the dipstick comes ou t just a scocsh but does come out rob

are you running a puke tank aka overflow tank? if not maybe that will help.

im open to suggestions 4 sure

Something else is up here. Blow by and steam sounds like a head gasket slight leak maybe. But something....

I have the same problem....plumb a good vent system for your valve covers

Rob,
What is the ID of your vent hose on the valve covers? If this is too small it will not relieve enough crankcase pressure and this can cause problems - oil leaks, blow by, etc.

Rick

crankcaqse ventilatuon
 

im only running two tall breathers one on each side of valve cover id like to see a good ventilation system , the guy above looks like hes running some sort of catch can can i see better detail thanks rob hows it going rick ?

Rob,
Can you show a picture of the type of breather you are using. One on each valve cover should be enough for your engine, assuming they are the right type of breather. Some breathers are very restrictive and do not do much.

Don't forget about our Fun Run 7/28 out of Northpoint Marina next weekend.

Rick

I run puke tanks k e valve covers -16 earls between also I run a oil therm. it got rid of all moisture

Heres my venting system. click on thumb nail to enlarge