|
the holes are 3/16 and drilled in a three-triangler patteren.i am running a ssmarine cross-over and this is the same t-stait mr gadgets talked about.i amrunning a blower on this motor also.temps are around 140-165 depending on water temp and how hard i run.also are your temp senders on the front of the motor?i ran mine at first on the rear/top of the manafold and the temp-gage always showed too hot....around 150-185.moved them to the front and temps read normal now.hope this helps
|
AZ Speed and Marine may have a high flow T-Stat. I believe I got a 120 high flow from them.
|
Originally Posted by bcfountain
(Post 2270097)
the holes are 3/16 and drilled in a three-triangler patteren.i am running a ssmarine cross-over and this is the same t-stait mr gadgets talked about.i amrunning a blower on this motor also.temps are around 140-165 depending on water temp and how hard i run.also are your temp senders on the front of the motor?i ran mine at first on the rear/top of the manafold and the temp-gage always showed too hot....around 150-185.moved them to the front and temps read normal now.hope this helps
|
Just spoke with Stainless Marine, and they say it needs the three holes. I'll post my results, thanks guys...
|
Just spoke with Stainless Marine, and they say it needs the three holes. I'll post my results, thanks guys...
|
PROBLEM SOLVED! three holes and another new thermostat. I now run @ 165-170 consistently
|
| All times are GMT -5. The time now is 07:14 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.