Kaama Help Needed
 

I have a set of KAAMA's on back of my 30' formula and 1 broke. Where do I get a diagram of the units and how do I find parts? Can anyone help me out here PLEASE!

Team Archer Marine 949-646-9778

They will be able to help you

I Have Diagrams And Some Parts, They Are Pretty Simple To Work On. What Happened To Yours. Give Me A Call Bruce 5197912790

Bruce Give me a call I left a message earlier i need to talk to ya!! 616-450-0261

most all the parts are over the counter type pieces.

Bruce I can not open the jpegs can you send them to [email protected] I do not know what happened but I can spin the prop with one finge4r. Trans is just great and I need a boot also. I can not find anyone who can help. Most people I have called said they can not help. I was ready to sell them both. I hope you can help. I am on my way to Vancouver with a 53 ft Silverton and will call when I get back to Fl.

what is wrong with your boot ? may have a used take off 4-u, but not in very good shape;;J

Bruce, luv 2-have the diagrams too ! :D please call 781-548-9300 so I can give u-my mail address thanks j

Ice! Call me about the boot at Don 727-364-8531 please.

Don you may be able to use a rubber raft repair kit to fix the boot?

I'm pretty sure I have the entire Kaama diagram on disk around here somewhere. I'll see if I can find it.

I might be able to help with a boot. I would need a dimensional drawing.
[email protected]

I have a manual for the Kamma and have rebuilt several. Feel free to call me if you have questions.

mike
402 968 7809

did you see my reply in the other post?

KAAMA Gimble Bearing Info
 

Boatman302, Do you also have a diagram or list of parts for the gimble bearing and shaft that goes through the transon. I need the 2 bearings and related shims and seals. Do you have the part numbers? I hear berry bearing makes most of the parts for the KAAMA section going through the transom. Thanks for your help on this.

Boatman302, Do you also have a diagram or list of parts for the gimble bearing and shaft that goes through the transon. I need the 2 bearings and related shims and seals. Do you have the part numbers? I hear berry bearing makes most of the parts for the KAAMA section going through the transom. Thanks for your help on this.