Offshoreonly.com - Which hose fitting or end would you use?

Page 2 of 2

Show 40 post(s) from this thread on one page

Offshoreonly.com (https://www.offshoreonly.com/forums/)

- General Q & A (https://www.offshoreonly.com/forums/general-q-20/)

- - Which hose fitting or end would you use? (https://www.offshoreonly.com/forums/general-q/180932-hose-fitting-end-would-you-use.html)

Strip Poker 388

03-04-2008 05:52 PM

Quote:

Originally Posted by LZH (Post 2470839)

I have aluminum tabs on my boat and have them rmoved right now. Is there somewhere I can send them to have this Ano Tuff Hard Coat anodizing done ?? This sounds like a great solution as opposed to paint or powder coating....

powder coat I would think would look better,The Anodizing ive seen is kinda like a flat to simi gloss

Jb-fse

03-05-2008 03:40 PM

Hard Coat

Hard Coat Anodizing Is Not Cheap,i Think You Could Power Coat Them Two Times For Less Than Hard Coating Once.

LZH	03-05-2008 06:59 PM

Quote:

Originally Posted by Jb-fse (Post 2472501)

Hard Coat Anodizing Is Not Cheap,i Think You Could Power Coat Them Two Times For Less Than Hard Coating Once.

Yes, but the labor involved in removing them is also a factor..../I'd rather remove them once, hard anodize and never have to worry about them corrroding again. I am in southern california, is there anyone here that can do it or I could send them out. Any suggestions appreciated.

All times are GMT -5. The time now is 03:05 AM.

Page 2 of 2

Show 40 post(s) from this thread on one page