|
Originally Posted by boatnt
(Post 2659441)
the only issue I still have is the radio going out during engine cranking,I never really paid attention to it before,I think that would be normal operation,Iam I correct ?????
|
Originally Posted by boatnt
(Post 2659441)
the only issue I still have is the radio going out during engine cranking,I never really paid attention to it before,I think that would be normal operation,Iam I correct ?????
|
after installing 2 bus bars,1 ground and 1 power,and 8 gauge wires,I took the boat out for a ride,all seem to be working fine and all gauge reading are now good with out any voltage drops/spikes.
Now why didn't the factory do it that way,how much could they have really saved.:rolleyes: |
Originally Posted by Chris Sunkin
(Post 2660512)
A deep cycle will spin a low compression small block just fine. The bigger you go, the worse they work.
Absolutely true. A brand new Interstate 27 DC would not spin my 502 . |
Originally Posted by boatnt
(Post 2662707)
.
Now why didn't the factory do it that way,how much could they have really saved.:rolleyes: Seriously- most boat manufacturers spend their money on what you can see and figure it'll not be their problem by the time your half-assed rigging takes a dump. Blame it on the consumer than demands flash over quality. |
| All times are GMT -5. The time now is 12:54 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.