It wasnt a slam, I've seen the set up and it is better than any other system Ive seen. Just preparing people for the cost. I even offered to rep their product as I was impressed.

And I know about customer service!! You know that.

Rock on!!!!!!!!!!!!! Its a Hustler nation!!!!! :eek:

Hustler nation!!!!! :eek: OH CHIT :ernaehrung004: Rudy is sharp as a tack and knows his system ...

so... what is the cost perunit for a typical installation start to finish per motor ? i know the specifics of each installation will be fractionally different but pick a specific motor set up and give me a rough idea of the cost, please.

Bill-
Do you use any other parts that compliment the ICE system?
John

Hey BIG Daddy give Rudy a call 1-302-367-4962 :ernaehrung004: what motors are ya runnin and wantin to spray ???

I,m using Valucraft -20 windshield washer fliud in my injection
system. It is 40%meth60%water
Lowers my EGT 300 degrees and raises the torque of each motor 300 foot lbs.

I gotta be easy on the sticks the Turbines will throw the 6 drive right off the back of the boat:eek:

OUCH :eek:

This is the best system on the market in the automotive world. http://www.alkycontrol.com/ I am sure they can make a system of any application and recommend 100% methanol for consistancy.

After logging 160* at WOT and 84* at idle, I thought about running meth in my two front tanks.

RunninHotRacing158 - how much lower were you AIT's after the meth install?

in the automotive world ........ you said it in 1 word automotive:rolleyes: Theres a BIG difference between 10 or 15 seconds in a car at the strip and holdin them sticks down for 30 miles at a poker run . my .02 :ernaehrung004: