Offshoreonly.com - now my valve covers wont fit!!!!!

Page 3 of 3

Show 40 post(s) from this thread on one page

Offshoreonly.com (https://www.offshoreonly.com/forums/)

- General Q & A (https://www.offshoreonly.com/forums/general-q-20/)

- - now my valve covers wont fit!!!!! (https://www.offshoreonly.com/forums/general-q/203510-now-my-valve-covers-wont-fit.html)

BenPerfected

02-20-2009 09:26 AM

one

thumper038

02-20-2009 09:31 AM

valve covers

I have a pair of 420 covers in swap shop for 75.00 + shipping the 420's had crane/merc roller rockers with the two rockers milled
these should work
Thumper :drink:

US1 Fountain

02-20-2009 09:29 PM

Quote:

Originally Posted by Fixxxer22 (Post 2803988)

i wonder if anyone has a port side gil. ine has a crack. im getting it welded but i must admit im a little queazy about it. also mr griff... thanks for the speedy shipping. it was everything i needed. thanks again

Same manifold for either side. Just have to swap the front and rear lower hose fitting and the 2 top manifold fittings around.

AIR TIME

02-20-2009 10:53 PM

Quote:

Originally Posted by Fixxxer22 (Post 2804413)

what are you looking to get out of them? you would be shipping to 52722

150.00 including shipping and my rockers did not have to be cut so they may be a little taller.

Planetwarmer

02-21-2009 04:03 PM

Do you really NEED valve covers? Of course not! Just keep some extra oil on board and hose the bilge out when you are finished for the weekend and forget the valve covers all together.

You may want to spread some kitty litter down in the bilge 1st and not run the motor with the hatch open. Oh and Halon may be useful too!:evilb:

Fixxxer22

02-22-2009 04:04 PM

or i could just wrap the engine in a big garbage bag?!?:angry-smiley-038: HAHAHA!

All times are GMT -5. The time now is 10:20 AM.

Page 3 of 3

Show 40 post(s) from this thread on one page