Go Back  Offshoreonly.com > Technical > General Q & A
502 Mag to 650 hp 540 Fuel system upgrades?? >

502 Mag to 650 hp 540 Fuel system upgrades??

Notices

502 Mag to 650 hp 540 Fuel system upgrades??

Thread Tools
 
Old 08-30-2009, 07:02 PM
  #1  
Registered
Thread Starter
 
Join Date: Aug 2007
Location: Greensboro,NC
Posts: 676
Likes: 0
Received 0 Likes on 0 Posts
Default 502 Mag to 650 hp 540 Fuel system upgrades??

I am building a new 540 motor and I am wondering what fuel system upgrades I will need. The engine started out as a 502 mag 415 HP with electric fuel pump only and the cool fuel system. I am switching to a late model 500 EFI fuel injection system with a Arizona speed mono blade throttle body and 50 or 55lb injectors. What else needs to be done to upgrade the fuel system?? The 540 has Dart pro 1 heads,741 cam, and EMI thunder exhaust producing 650HP. Any input is appreciated. Thanks, Jeff Wurl
jwurl is offline  
Old 09-01-2009, 08:36 AM
  #2  
Registered
 
Join Date: Feb 2004
Location: MT. JULIET, TN.
Posts: 3,710
Received 2 Likes on 1 Post
Default

Trash the cool fuel. Put an A1000 pump or similar with a regulator. Put a 1/2" pickup and lines and return it to your tank.
kennyo is offline  
Old 09-01-2009, 01:03 PM
  #3  
VIP Member
iTrader: (1)
 
Smitty's Avatar
 
Join Date: Apr 2001
Location: Chicago il
Posts: 4,213
Received 0 Likes on 0 Posts
Default

Use 1/2 lines from tank all the way thru to the fuel rail. And also make a return line back to tank for unused fuel.
__________________
Want your ECU tuned right?? Call Mark at Precision www.pmefi.com
Smitty is offline  
Old 09-01-2009, 07:36 PM
  #4  
Registered
Thread Starter
 
Join Date: Aug 2007
Location: Greensboro,NC
Posts: 676
Likes: 0
Received 0 Likes on 0 Posts
Default

Would you run a water filter or not?? What kind of fuel pressure would you run? Thanks, Jeff
jwurl is offline  
Old 09-01-2009, 09:48 PM
  #5  
Registered
Thread Starter
 
Join Date: Aug 2007
Location: Greensboro,NC
Posts: 676
Likes: 0
Received 0 Likes on 0 Posts
Default

Are you reffering to adding a larger Wix filter to the original Merc water seperator. Will the original filter head flow enough? Thanks again, Jeff
jwurl is offline  
Old 09-01-2009, 10:08 PM
  #6  
Registered
 
Join Date: Jan 2004
Location: Tennessee
Posts: 4,480
Likes: 0
Received 40 Likes on 16 Posts
Default

No, you need a larger filter head.
Fuel pressure will depend on the tune. You ecm will be tuned for a particular pressure. Should be around 40 psi.
Eddie
Young Performance is offline  
Old 09-02-2009, 04:57 AM
  #7  
Off the Radar
Platinum Member
 
Linster's Avatar
 
Join Date: May 2001
Location: Short Pump or Colonial Beach, VA
Posts: 1,097
Likes: 0
Received 1 Like on 1 Post
Default

I took a 500EFI with close to the same setup. We put in a Scat crank & Rods, 4.25, Bored the block to 4.50", JE 10cc small dome pistons, 741 cam, Dart Iron Eagle heads ported, Arizona mono blade, 9.7CR. I sent it off to Precision to tune & dyno test. The motor made 700 lbs of torque ay about 4200rpm & 631 HP at about 5200 rpm. The hp rolled off quickly after that. The intake will be an issue if you plan on spinning it much over 5000. The dyno showed vacumn increasing in that range which meant it was running out of air. The motor works great, with a different manifold you may get 650-675 HP. The fuel system is all stock 500 EFI with the exception of installing 50lb injectors. Not any fuel isses so you will not need to do any of that. The motors are in t500hps boat. He can provide dyno sheets if you are interested

Good Luck
Linster is offline  
Old 09-02-2009, 07:51 PM
  #8  
Registered
Thread Starter
 
Join Date: Aug 2007
Location: Greensboro,NC
Posts: 676
Likes: 0
Received 0 Likes on 0 Posts
Default

Linster..Is that 500 EFI running both a mechanical and electric fuel pump or just the electric. Thanks, Jeff Wurl
jwurl is offline  
Old 09-03-2009, 02:02 PM
  #9  
Registered
Platinum Member
 
Join Date: Feb 2007
Location: RICHMOND,VA.
Posts: 41
Likes: 0
Received 0 Likes on 0 Posts
Default

yes they are running both pumps
SIDE JOBS is offline  
Old 09-04-2009, 12:09 PM
  #10  
Registered
 
ZXXX Donzi's Avatar
 
Join Date: Jun 2004
Location: Tennessee
Posts: 834
Likes: 0
Received 2 Likes on 1 Post
Default

Originally Posted by kennyo
Trash the cool fuel. Put an A1000 pump or similar with a regulator. Put a 1/2" pickup and lines and return it to your tank.
That is certainly in the right direction.

When are you coming out to CH?
ZXXX Donzi is offline  


Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.