Cigarette TG- List your Setup and Speed
 

I am doing some reasearch on other Cigarette TG owners setup and performance.
Please list the following:

Year and Boat
Flat Bottom or Step
HP
DRIVE
Drive Ratio
Prop
Pitch
Lab Finished or Non-Labbed.
Speed

Here is my setup

1994 Cigarette Top Gun
Flat Bottom
Twin 610hp
Bravo 1
1.5 gear ratio
28 Pitch Maximus Prop
Non-Labbed
Top Speed - 68mph

1984 Flat Deck
Flat bottom w/notch
twin 1100hp.
#3A or #5
1.5 ratio
18x32 4bbl.
non-labbed
90-92 w/3A's and 100-102 w/#5"s and box's

Okay I see you not gotten a lot of responses but your speed seems way off.
I have a 93 Cafe
I am running twin 550hp
1.5 ratio
26p 4 blades(labbed by BBlades)
Top speed 1/2 tank of fuel 2 guys and a good chop 78.9gps
Boat runs a consistent 75-76mph

what rpm's ? 28 maximus not a great match for your combo imho

Yeah I agree something is wrong you should be seeing speeds 75 +
What rpms are you seeing?

1990 Cafe
Blown 502's with ROUGHLY 580-600 HP (I guess closer to 580)
Imco (Bravo's)
4 Blade 26's
Probably a 75 MPH boat
I have seen 73 without staying in it very long, and with a good amount of fuel/etc.... on board.

51-5200rpm.

Be sure to search the CIG section - LOTS of discussion on what everyone runs.

2002 Cigarette Top Gun
TS Bottom
Twin 575SCi (628 hp)
Bravo 1
1.5 gear ratio
32 Pitch Bravo Prop
Non-Labbed - but flat bladed
Top Speed - 94mph

I am only getting 4400rpms with my 28 Pitch Non-Labbed Maximus Props. My engines were dynoed at 605hp at 5500rpm. That is why I am selling them in the classified. The reason I put this post up was to figure out what props I should get. I don't know what I should get.

I think I need one of the following.
26 or 27 Pitch 4 blade Bravo 1
26 Pitich Maximus Labbeded.
26-27 Pitch Hydomotive 5 blade Non-labbed.

What do you think, anybody....

I would suggest 26p bravo 1 and spin the props in. I have an older strait vee and spinning in made a large difference.

I would say stay with bravo 4 blades, you would probaly be good with 26p 4 blade bravo and could gain a couple of mph by going with 28p 4 blade labbed finish.