500 hp carb set up
ok finishing my 500hp, +.030, factory cam, intake, but has stainless marine full headers, doing up a 800 DP, just cause I have one, milling the airhorn, where's a good place to start jetting wise on this setup...Thanks Rob...also how much total timing to run on 87 at times..
|
ttt
|
77p - 92s with a 4.5pv in the primary. This assumes air bleeds are fixed and original. You could also get the hp500 specs and do the staggered jetting.
34 degrees timing all in. |
Holley 800cfm HP500 stock jetting is:
Primary - Port 81, Stbd 75 Secondary - Port 89, Stbd 93 6.5 PV in the front. The secondaries don't have a PV. If I was rejetting, I would probably just use 77 primary jets and 91 secondary jets. |
thanks guys, just what I needed...and just getting ready to put carb together !! Rob
|
http://www.mercruiserparts.com/Show_...OR+AND+LINKAGE here mec setup:drink::drink:
|
All times are GMT -5. The time now is 03:27 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.