|
Cam question for water reversion
Hi I am getting a Gen VI 540 with Merlin Grumpy Jenkins heads and have a Hydraulic Roller cam that has these specs.
cam timming @50 duration 236 intake duration 244 exhaust lobe seperation 112 lift intake 610 lift exhaust 632 I have Imco Super flow wet exhaust. Will I have an issue with this set up. Thank you in advance. |
I would say probably not, but there are no guarantees. That is a Crane 741 cam. Plenty of people use that cam on 502-540ci engines. The Imco exhaust will most likely be the determining factor.
|
What HP will that cam make?
|
If you have the A Pipe you would be safer than the shorty riser Imco makes. I have a friend who has the Imco setup with the A Pipes with a HR cam with 240/248 duration @50 on a 540 with ported steel heads, with no probelms. His idle is set at 850 to 900......
|
Originally Posted by Floatindirty
(Post 3142354)
What HP will that cam make?
|
Originally Posted by Floatindirty
(Post 3142354)
What HP will that cam make?
|
Originally Posted by Griff
(Post 3142327)
I would say probably not, but there are no guarantees. That is a Crane 741 cam. Plenty of people use that cam on 502-540ci engines. The Imco exhaust will most likely be the determining factor.
I am with Griff... |
I have the A pipe not the shorty, so I should be safe with that then. I will run the motor for a while and remove the manifolds and inspect before I go out and blow an engine.
Thank you all |
| All times are GMT -5. The time now is 06:14 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.