Headers and reversion
 

Just switched from gil manifolds to hardin shorty headers. Gettings lots of reversion now and all the milk that goes with it. Is it common to get this problem with all types of headers. The tails are 28 in long. Is going semi dry and longer all I can do. I really doubt hardin will refund my 5 grand. I should have done more research. Opinions?

fIXX
 

WOULD THIS BE A FOUNTAIN? make sure you put the turbulators back in or your going to have problems..

http://www.keitheickert.com/detail.aspx?ID=2586

do the turbolators make that much of a difference. I run the same headers and have the same issue but only on one of my motors. could it be the rust holes in the turbolators? low idle? good luck brother....I have the same issue.

drag this a 3 yr old trend,,may want to pm him and see what the out come was.

lol....good call. didn't even pay attention to the date of the post.

I'm having the same problem but with CMI's on a 05 525 set up the headers are not leaking its coming back up the tail pipe.