Offshoreonly.com
Page 4 of 4
« First
2
3
4
Show 40 post(s) from this thread on one page

Offshoreonly.com (https://www.offshoreonly.com/forums/)
-   General Q & A (https://www.offshoreonly.com/forums/general-q-20/)
-   -   Copper in the Oil Analysis (https://www.offshoreonly.com/forums/general-q/242244-copper-oil-analysis.html)

DesertRage 06-12-2012 10:13 AM
You could also start cutting your oil filters open to see if you are getting debri. It will take a couple of filters for you to determine what a "normal" amount of particles will be. If something is going wrong you should see a lot of junk in the pleats.

BenPerfected 06-12-2012 08:42 PM
Originally Posted by DesertRage (Post 3707687)
You could also start cutting your oil filters open to see if you are getting debri. It will take a couple of filters for you to determine what a "normal" amount of particles will be. If something is going wrong you should see a lot of junk in the pleats.
+1 we do this every oil change. You will likely see some wear.


All times are GMT -5. The time now is 06:37 PM.
Page 4 of 4
« First
2
3
4
Show 40 post(s) from this thread on one page


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.