502 MPI Cams
Last year i had my 2 502 gen6 mpi re built from scatch including the following:
Re bored 30 thou and balanced Wiseco domed pistons with comp eagle uprated con rods Edlbrock Ali heads from summit racing: EDL-61559 Comp Cam CCA-01-445-8 From summit racing EMI thunder Exhausts The engines i ran for one season last year, i am fairly happy with the power but still think they are lacking performance, so i am going to replace the cams plus would like to send the ecus back to get them remapped. I have been looking on here at the crane cam 168741 and 168731, and hope for a bit of advice as to which way to go and who to go for for the remap, preicison marine has been recommended to me by a couple of friends. also the engines have fuel regulators fitted to them and would like to know what pressure to set them up at. thnaks for any help in advance, Charlie |
Forgot to mention the comp ratio is roughly 9.5:1
|
Call Bob Madera at Marine Kinetics and have him make you a custom cam that will run better than you ever thought possible and make power as well. Tell him Smitty sent you !!!
585-654-8583 After you get the cams in and the motors back together, call Mark at Precision Marine to re-tune your ECU's www.pmefi.com |
Fixx
Originally Posted by Smitty
(Post 3317525)
Call Bob Madera at Marine Kinetics and have him make you a custom cam that will run better than you ever thought possible and make power as well. Tell him Smitty sent you !!!
585-654-8583 After you get the cams in and the motors back together, call Mark at Precision Marine to re-tune your ECU's www.pmefi.com |
Thanks for the post so far, i havw heard on here about Marine Kinetics, but due to limited time available, i may need to buy them off the shelf, so just wonder which one to go for.
Also where would you you put the rev limiter roughly, i know possibly depends on the cams chosen too |
Originally Posted by Smitty
(Post 3317525)
Call Bob Madera at Marine Kinetics and have him make you a custom cam that will run better than you ever thought possible and make power as well. Tell him Smitty sent you !!!
585-654-8583 After you get the cams in and the motors back together, call Mark at Precision Marine to re-tune your ECU's www.pmefi.com |
Originally Posted by Smitty
(Post 3317525)
Call Bob Madera at Marine Kinetics and have him make you a custom cam that will run better than you ever thought possible and make power as well. Tell him Smitty sent you !!!
585-654-8583 After you get the cams in and the motors back together, call Mark at Precision Marine to re-tune your ECU's www.pmefi.com |
Call Bob and he can set you up a cam and have it to you in a week. It doesn't take that much longer to get one of his custom cams.
|
All times are GMT -5. The time now is 10:59 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.