TRS Engine Harness bracket and wireing
 

I cant figuer out where the Engine bracket goes on this for the wiring harness. And if anyone know where the wire plug into that would lso be great but not a huge deal.
Does anyone have Pics of dressed engine they could post?
-Mike

Bolts on at the top of the bellhousing on mine.

Have a Pic by chance? I tried to place the bolt holes on the bell, engine and engine mount but nothign seems to line up
-Mike

You are welcome to take a road trip up to my shop if you want and see how mine are installed.

Jon

Id be happy to if you dont mind of course
-Mike

Ya no problem Arti knows how to get in touch with me.

Did you try the back of the cylinder head?

Yup 1st place I check was back of the head.
-Mike

Here is a pic of it dont know if it helps.
-Mike

Kinda looks like it might fit in the center on top of the Bell Housing. Some bell housings have two tabs sticking up that it may fit up too.

That's the same bracket as mine and it does bolt to the top of the bell. However, I have a couple of other merc bells that don't have the spot needed to mount that so maybe you have the wrong one. Maybe do a little fabbing? Only my girlfriend knows how to post pics for me. she's not here, Sorry

OK ill check my other bell maybe that has it
-Mike

was able to swing by the marina last night to verify that the bracket does bolt on back of the engine via the bell housing, (see pics). It is kinda hard to take good pictures because of the location. Hope this helps.

Stinger, do you have a Merc Trans ll or a Borg-Warner ?
Merc Trans ll should have 2 threaded holes at the top of the bell housing. That would be like in cliff's pics.
If you have a B-W trans you may need a different bracket. If you do have a B-W does it have a top mount starter with the coolers in the bellhousing ? They have another bracket which I think that one bolts to. Part #9 in this diagram.
http://www.perfprotech.com/store/ass....aspx#assembly

Exactly what engine, trans and bellhousings do you have ?

Merlin 540's with a TRS coolers on Bell. I checked the Bellhousing and non of the holes lined up.
Thanks for all your help guys
-Mike

If you have the TRS dual cooler bell than you need part #9 in the diagram also to bolt it to.
http://www.perfprotech.com/store/ass....aspx#assembly

is there a good pic of it?
-Mike

The bracket, part #9 in the diagram is bolted on with the top 2 bolts which bolt the bell housing to the engine block. Then the bracket you have bolts on to this bracket in the 2 remaining holes. Bracket #9 in the diagram is no longer availiable so you may need to fabricate one which should be fairly easy unless you can find one somewhere used.

OK thanks I will see what I can come up with tonight. Im just about done rggine the engine now and the 2nd one is to come tuesday.
-Mike

This is what I have came up with so far.
-Mike