Labor estimates - K-planes, Hyd. steering
#1
Guest
Posts: n/a
Labor estimates - K-planes, Hyd. steering
Looking to get some idea of what is a reasonable rate (east coast) for removal of (small) Bennett tabs and installing 280S K-planes and pumps.
Also looking to get an idea of what to pay (labor) for installation of hydraulic helm unit (converting tie-in to full hydraulic).
thanks,
Mark
Also looking to get an idea of what to pay (labor) for installation of hydraulic helm unit (converting tie-in to full hydraulic).
thanks,
Mark
#2
Registered
Mark,
I don't know about the k planes but if you are handy at all you can do the helm unit and hoses. It took me about 1 full day to install an full unit last year and it was my first time. measured a lot and sweated drilling holes in my boat. The hard part is done on yours and I bet a few hours would get the remainder of the system installed.
I don't know about the k planes but if you are handy at all you can do the helm unit and hoses. It took me about 1 full day to install an full unit last year and it was my first time. measured a lot and sweated drilling holes in my boat. The hard part is done on yours and I bet a few hours would get the remainder of the system installed.
Thread
Thread Starter
Forum
Replies
Last Post
kook
General Boating Discussion
17
06-07-2002 10:54 AM