|
MEFI 1 xdf file
Has anyone modified the .xdf definition file for the MAP/RPM/BPW table to add MAP and RPM rows and columns?
I'd like to do that and see if the MEFI 1 will take the added values and run appropriately. |
can't be done. change to a MEFI 2
|
What can't be done, change the table? Or can you change the table but the MEFI 1 won't recognize it?
|
you can modify the XDF file but the ECU will not take the Flash. The memory registers are not adequate
|
Is this for all MEFI 1 controllers or just the early models? There were about 3 renditions if I recall.
If I were to attempt an upload I'm assuming the load would fail and the motor would simply not start correct? |
all MEFI 1
Originally Posted by Trash
(Post 3471700)
Is this for all MEFI 1 controllers or just the early models? There were about 3 renditions if I recall.
If I were to attempt an upload I'm assuming the load would fail and the motor would simply not start correct? |
| All times are GMT -5. The time now is 05:59 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.