Fel-Pro part # needed
 

Could someone give me the Fel -Pro part # for a intake gskt set for a carb 502 w/ hp500 intake manifold ( no bolt holes between the runners) much appreciated. I'm going to lick this milky oil problem yet !!!

syringa

I find that Fel-Pro #1274 fits the heads the best, and don't worry about the unused holes.

syringa,
I also put a very thin film of rtv on the heads around the water passages for good measure.

I use # 17341. Felpro 502 w/ rect ports

Funny thing I just got a pt # 1275 from the guy that dynoed my engine.. What's with all these different numbers??

Your dyno guy is right on.
 

Syringa,

The 1275 set does not have the extra runner hole (just like you asked) :rolleyes: and also has the heat exchange passage blocked off.

The 17341 that I use is slotted for the extra hole. Sorry

Jerry