endeavour32

iTrader: (4)

I've got a Kiekhaefer Mechanical Trim indicator that has the wrong card in it for my application. I need a card that has IN at the top of the Drive section, mine has OUT. If you are switching from the actuators that mount on the rams to a style that mounts on the upper part of the drive this is what you need.

Dave M

On my last boat I had the actuator that mounted where the stock trim sender was and I used the same card as what you have except it was for a single drive.

endeavour32

iTrader: (4)

Correct, that is what this card is for. The IN card is for the ram mounted actuators, which is what I have.

Dave M

OK, I get it now.

I have a ram mounted indicator now and it is the reverse of the pic you posted except it says "Down" instead of IN.

Underdog88

I should have one for you. I removed mine and made my own sticks which protrude out of the top of my new dash. The old panel is in the shop somewhere I'll take a look.

Underdog88

I found my old one if you need it. It has a charcole gray face and not black as your's looks but says in at the top
Yours if you need it.

97FASTech

iTrader: (6)

END32, where did you come across the the white indicator that goes in the gauge. Looking for two.

coolmedown

underdog88..I may want to purchase that indicator from you..Let me know. You could swap him the card as I need his and en32 could ship his to me

Underdog88

Mailed the "card" to Mike today. Didn't see your post till now. I have the frame, lil white pointers and back inside parts. I would imagine he would give you his. What goes around comes around

Shoot me an email to mark at underdogracing com and you can have it all.

I made my own sticks and used only the original cables and cable holders so I have the rest laying around.

97FASTech

iTrader: (6)

When all this gets to the proper person, I'm looking for two white indicators to go in the gauge. Anyone have extra?

Thank you