|
The Daytona Sensor Box is excellent! You can Map your own Curve, set rev limiter, also dial in advance curves that are preset, they will work with a mag trigger or Merc Hall effect type. You can purchase a interface cable and also log data. Have been set up with them since they came on market again. They have made improvements on the electronics that Crane wasn't willing to do.
|
Originally Posted by cstraub
(Post 3608525)
100% USA made. They have improved the box over the old design. We thrashed one box as a dyno unit for and had over 30 engines on it, then put it in a drag car, then put it in a late model. No hiccups.
|
I bought one as a spare and to go to the dyno with. Worked fine. Use the coil supplied. Other coils like the MSD blaster did not work which we found out after 1/2 day troubleshooting.
|
Does anyone know how the customer support is at Daytona Sensor?----or are they too young/new of a company to know yet?
|
Originally Posted by KAAMA
(Post 3610031)
Does anyone know how the customer support is at Daytona Sensor?----or are they too young/new of a company to know yet?
|
Originally Posted by stevesxm
(Post 3608136)
why do you keep buying them ? why would you use ANY component that you have to carry a spare on your keychain just to make sure you can get home ?
You seem like a knowledgeable man, what do you use? |
I have 2 good low hour crane boxes if someone is looking for spares
|
I have always used some kind of ign box, first MSD then after my old box got physically damaged I bought a MSD marine boxe. The marine boxes were such JUNK that I will NEVER buy a msd product again, 3 boxes, all had different problems, one of them was completely doa, ended up buying a ignition tester, saved alot of time trouble shooting there junk. I am currently running a crane box, it has been trouble free. I am lucky too, if box does start to act up on a mefi system you can simply bypass it, Smitty
|
Also running HI6-M
Originally Posted by cocktails
(Post 3606595)
To all the OSO experts. I have been running the Crane HI6-m Marine ignition boxes with my 502 Blower motors. I had a box fail and realioze that these boxes have been dicontinued with none or very few around the country.
I spoke to the guys at Daytona Sensors. They are ex Crane guys and seem very knowledgeable one being the Head design engineer from crane that desined the Hi-6M. i believe that is correct. They offer a new and improved ignition box similar to the Hi-6M . Has anyone used their products.?? Any questions or comments. They seem like they are a good option. Not cheap though. thanks for all comments and info. THX |
I've been running the MSD 7000 series marine boxes for 4 seasons now with no issues, knock on wood. I think alot of it has to do with how and where you mount them. Any of them.
|
| All times are GMT -5. The time now is 10:40 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.