Pipe to hose fitting
Anybody know where I can get a 1" pipe to 1 1/4" hose fitting in stainless? I've found them in bronze but need stainless.
Any ideas guys? Thanks! |
1 inch pipe is basically the same size as 1 1/4 inch barb. Machine some grooves in a pipe nipple if you can't find anything. As I typing this I remember Teague had a bunch of SS 1 1/4 stuff.
|
I'm sure I have something at the shop in Pompano
|
Originally Posted by kvogt
(Post 3656267)
1 inch pipe is basically the same size as 1 1/4 inch barb. Machine some grooves in a pipe nipple if you can't find anything. As I typing this I remember Teague had a bunch of SS 1 1/4 stuff.
Originally Posted by Mbam
(Post 3656314)
I'm sure I have something at the shop in Pompano
|
i would do bronze in salt. unless you are willing to change out the black pipe nipple at least once a year. 3 bucks at Lowes though...
|
I'm sure I have 2, if not I can make them. I normally keep 6" stainless nipples around for just that reason. I'll check in the AM.
When I was much younger (before I had a lathe) did the straight nipple/hose clamp thing and wound up in the water with my hand over the intake to keep the boat from sinking when the hose came off. Might have only been 1 clamp then, i don't think i knew any better. Now we turn down the nipple and leave a bead on the end. And 2 clamps - always! |
Originally Posted by Mbam
(Post 3656374)
I'm sure I have 2, if not I can make them. I normally keep 6" stainless nipples around for just that reason. I'll check in the AM.
When I was much younger (before I had a lathe) did the straight nipple/hose clamp thing and wound up in the water with my hand over the intake to keep the boat from sinking when the hose came off. Might have only been 1 clamp then, i don't think i knew any better. Now we turn down the nipple and leave a bead on the end. And 2 clamps - always! PM me a # I can call you at tomorrow. Thanks a lot! |
CP Performance has some really nice fittings. They are investment SS and then polished. Very nice pieces. I use them exclusively and love them.
http://www.cpperformance.com/c-640-c...-fittings.aspx Eddie |
McMaster Carr has SS pipe to barb fittings also. Just for future reference. :)
|
Originally Posted by Young Performance
(Post 3656654)
CP Performance has some really nice fittings. They are investment SS and then polished. Very nice pieces. I use them exclusively and love them.
http://www.cpperformance.com/c-640-c...-fittings.aspx Eddie That's exactly what I need, thanks again! |
All times are GMT -5. The time now is 02:01 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.