Engine rotation
From what I have read here getting a replacement engine for the project boat should be simple enoough. Since it is the port engine that is missing, I need one with standard rotation. All I need to do is find a donor boat with a single 454 /Bravo 1 set-up and it should pretty much be plug and play, as long as it is the same generation.
|
"ALL" Mercruiser sterndrive engines are left hand rotation as viewed looking at the back of the boat from outside. Flywheels turn counter clockwise. Propeller rotation is determined in the drive.
|
I thought that was on the newer ones. If this is the case all I need to do is find a Mercrusier from the same generation. That will make the search much easier.
Thanks |
Is this for the 1990 Webbcraft? If so and assuming the exisiting engine is original than it should be a Mark lV. Gen V started in '91. You can check by the large casting number on the top rear of the block.
|
Yup, its for the Webbcraft project. The port engine is completely gone. The old guy that owned it took it to some shop for rebuilding, died and nobody knows where the engine is. I'm hoping to have pictures from the engine compartment tomorrow.
|
fixx
Originally Posted by inthetundra
(Post 3723634)
Yup, its for the Webbcraft project. The port engine is completely gone. The old guy that owned it took it to some shop for rebuilding, died and nobody knows where the engine is. I'm hoping to have pictures from the engine compartment tomorrow.
|
They were original, 330 hp w/ Bravo 1 drives. For right now, this is the budget boat, so it will get an engine to fill the hole. A pair could be in the future if all goes good.
|
ok, what is your budget and how much is left in the bilge? manifolds, flywheel alt-ps pump-bracket? motor mounts? there or gone? there are some decent looking truck motors on ebay for around 600 to 1600. same with craigslist. if the parts that make it work with your boat are gone, makes it tougher. but you will be able to get all the above mentioned stuff here on the swap shop. there are a couple of parts motors and some completes there too. you might wanna see if you can check the guy's house. he might have a pile of stuff he pulled off motor before taking it to the engine shop. his friends might also know who to see for where he got engine work done. maybe put a wtb post in the swap shop with a list of what you are missing...
|
The hatch is open.....pretty clean and not hacked up. Just need a complete set-up
http://i25.photobucket.com/albums/c6...a/c932c9ae.jpg http://i25.photobucket.com/albums/c6...a/3247f841.jpg |
looks tobe a 454 365 hp .ck the intake should be aluminum
|
All times are GMT -5. The time now is 06:25 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.