|
Those look super nice. Engine lines go to the remote filter head and those two on the adaptor loop to the oil cooler?
|
Bump Anyone install an Earl’s 504 on a Gen6? They included a 7/8” spacer to fit in the oil filter recess on the pad, but no hardware to make up the difference. Wtf? Theyre owned by Holley these days so support is miserable. |
Just a smidge short. The 13/16” threads goes into the block, obviously, but there’s nothing to extend that nipple up to bridge the spacer https://cimg8.ibsrv.net/gimg/www.off...19914207c.jpeg |
I had to use one of these on my block to get my thermostat to mount. I really like my thermostats they cleaned up my rigging immensely.
https://www.summitracing.com/parts/aaf-all92000 https://cimg7.ibsrv.net/gimg/www.off...f21a38ed06.jpg |
Originally Posted by Rookie
(Post 4656654)
I had to use one of these on my block to get my thermostat to mount. I really like my thermostats they cleaned up my rigging immensely.
https://www.summitracing.com/parts/aaf-all92000 https://cimg7.ibsrv.net/gimg/www.off...f21a38ed06.jpg |
I use a 504 and if I'm not mistaken the 504 has the blue ring for use with Mark 4 blocks where the filter pad is recessed. I think you needed the 503 for a Gen 6. They don't use that spacer. Probably uses the same thermostat but might be a different union in there, not sure. But don't need the blue ring for a gen 6. Not sure that blue spacer ring even mates right to a Gen 6 filter pad. You got 7/8" more space than you thought you had!
|
| All times are GMT -5. The time now is 01:08 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.