Rebuilding my 99 Baja 502 Mag MPI
 

Ordering up all my parts to get my procharged 99 H2X back on the water after sitting in storage from melting a piston :/

So my engine builder told me to get standard bearings for both rod and mains as they were perfect and not scuffed so just to replace them. So with all the options i think these bearings are correct for my build?

MS829V For mains
CB743V For rods.


This for my top end gasket kit
Fel-Pro-17207

Now i just need to find out which JE pistons to use. The motor is going 30 Over. Any one know which je piston will work for this motor?

Thank you very much just want to do it right and not send back parts over and over :)