Offshoreonly.com
Page 2 of 2
1
2
Show 40 post(s) from this thread on one page

Offshoreonly.com (https://www.offshoreonly.com/forums/)
-   General Q & A (https://www.offshoreonly.com/forums/general-q-20/)
-   -   Lost forward/ reverse. Help!!!! (https://www.offshoreonly.com/forums/general-q/299234-lost-forward-reverse-help.html)

28Eliminator 07-04-2013 09:01 AM
Originally Posted by 29Fever01 (Post 3953660)
I was just looking in the engine compartment near the transom and didn't see any debris like rubber shreds, nor smell anything like Burt rubber. If it was the coupler would it be completely obvious and smell strongly of burnt rubber or not so much? Is there anything else I can do to troubleshoot or narrow it down before I take it somewhere?
If the splines strip out you will see nothing, but if you can see the input shaft from the drive behind the bell housing, it should spin with the motor. If it doesn't the coupler is bad. I had one go bad trying to get on plane and It will create a boom also, however it is probably the drive.

welfare racing 07-07-2013 07:13 PM
that happened to mine, all it was was the shift dog in the upper (snapped in half)....1 alan screw and R&R of the drive...it is located behind the back cap (where the HYD. steering mounts)


All times are GMT -5. The time now is 10:38 AM.
Page 2 of 2
1
2
Show 40 post(s) from this thread on one page


Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.