Biggest cam with CMI E tops
#1
Registered
Thread Starter
iTrader: (2)
Biggest cam with CMI E tops
what's the biggest cam I can run with the factory 500efi CMI's without having reversion problems
Last edited by Drock78; 08-10-2013 at 05:10 PM.
#3
Registered
Thread Starter
iTrader: (2)
im looking at a going a different route with the engine since i lost a cylinder in mine. I want to still be able to run my headers and my switchable exhaust. looking going back to a carb motor but the motor im looking at is running a large solid lifter cam instead of hyd. and needs to run dry exhaust so I want to change the cam out so i can run my exhaust
#6
Registered
iTrader: (4)
Jim runs a real mild cam on his 780HP 565. 230/236.
He can spec a cam. With those heads the lift is important.
I think the same cam he uses would be great in that engine.
I would run those solid Isky's on his hyd roller like I do. Lash them to 0.006"-0.007" and hold on.
They were sent out to Isky and rebuilt .
He can also order the cam for you.
It was a beautiful weekend out in GH so get at it! It won't last
He can spec a cam. With those heads the lift is important.
I think the same cam he uses would be great in that engine.
I would run those solid Isky's on his hyd roller like I do. Lash them to 0.006"-0.007" and hold on.
They were sent out to Isky and rebuilt .
He can also order the cam for you.
It was a beautiful weekend out in GH so get at it! It won't last
#7
Charter Member # 55
Charter Member
Cam choice will depend on many other factors. It depends on the cubic inches of the engine and head flow.
A cam that causes reversion in a 454 won't necessarily revert water in a 502.
A cam that causes reversion in a 454 won't necessarily revert water in a 502.