Wow, this is getting deep.

While we are at it, lets skip over fresh plugs, fuel pressure check, ignition coil etc. I think you should tear the engine apart again. Maybe the crankshaft was installed upside down. or maybe the wrist pins are .000001 to tight.

Someone mentioned a valvetrain problem, because "the blower is making boost". Why wouldn't it make boost? A roots blower will make boost dependent on throttle position, even if there is no fuel, spark, or RPM. At 2500RPM, if you mash the throttles under load it should go to max boost.

Don't know, maybe miscommunication, email overlooked, I have no clue. I knew what they were from the hours of communication Bob and I had, but I did not have the actual cam cards. I guess it was just a good learning experience for me cause Valako taught me how to degree everything and set my engines up. (teach a man to fish, lol) My engines turned out exactly how we spec'd them and everything was spot on.

you said you have confidence in the builders ability,with the proper equipment degreeing a cam is quite simple,it there a reason you wont say who the builder is?