MLS or Performance head gasket
I am running a Procharged 454 with iron Gen 4 heads on a Gen V block and 5 psi of boost. Wondering do I run a MLS gasket, either Cometic or Felpro or run the Felpro 1037 performance gaskets? Next question is, Cometic or Felpro if the plan is MLS and why?
|
MLS, Tried both, had better luck with the Felpro
|
You could probably get away with the standard Fel Pro, but either of the MLS gaskets would be cheap insurance.
Eddie |
My understanding is that you have to make sure you have the proper finish on the deck and head surfaces to run the MLS gaskets. Most MLS gaskets need an RA finish of around 20-30. I don't think it is an issue very often with modern milling equipment that most shops use now, but something to be aware of.
|
Originally Posted by Budman II
(Post 4125491)
My understanding is that you have to make sure you have the proper finish on the deck and head surfaces to run the MLS gaskets. Most MLS gaskets need an RA finish of around 20-30. I don't think it is an issue very often with modern milling equipment that most shops use now, but something to be aware of.
|
All times are GMT -5. The time now is 03:06 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.