Mercury efi to holley efi. How to get the correct throttle throw.
I haven't got around to correcting this issue on my boat after going to holley efi. Is there a adapter to get full throw? Half throttle is full throttle right now. Thanks
|
You can change most likely change the mounting hole on the throttle levers.
|
Originally Posted by indysupra
(Post 4160249)
I haven't got around to correcting this issue on my boat after going to holley efi. Is there a adapter to get full throw? Half throttle is full throttle right now. Thanks
|
Show us a picture of you linkage set-up.
|
Shifters don't have other throws on them , that was my first guess. Don't have a pic but my current setup is this adapter on the t/b. Yes 1000cfm
http://www.michiganmotorz.com/thrott...FZTm7AodxnIAug |
After doing the same swap as you, I ended up with the same issue. The problem was solved by making an extension bracket out of plate aluminum and bolting it to the throttle body lever assy.Then attaching the cable to the extension bracket. It works great, and the throttle handle moves full sweep now.
|
I just looked at a 2000cfm TB, you should have a little over 3" of travel on your control cable. If not; something is not correct in control movement.
|
That's about right. It opens up the t/b all the way but is only half way on the sticks.
|
Originally Posted by Griff
(Post 4160296)
You can change most likely change the mounting hole on the throttle levers.
Closer to pivot point on Throttle or further from pivot point on tbody. I think I have that right. It's Sunday AM. LOL. |
Originally Posted by SB
(Post 4160508)
Yup. Or t-body.
Closer to pivot point on Throttle or further from pivot point on tbody. I think I have that right. It's Sunday AM. LOL. |
All times are GMT -5. The time now is 12:14 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.