|
hey dudes... I'm sure if you read the ultra fine print on a majority of the filters, you'll find WIX is the mfg
|
http://i734.photobucket.com/albums/w...ps0roh9plr.jpg
Do these filters make my block look small? Napa 1773. Each hold about 1 qt. I believe 18 micron rated and 30 psi BOV setting and high pressure GM bypass valve in block.. With the tighter filtration rating, I wanted to increase the surface area to mitigate the slower flow through the media.....then I doubled it. They operate in parallel. With running a thermostat, I have zero problems with oil temp. All 5/8" ID lines and Parker push-lock tubing. |
Sweet looking setup you have there.
|
Ii
Originally Posted by Gimme Fuel
(Post 4279460)
http://i734.photobucket.com/albums/w...ps0roh9plr.jpg
Do these filters make my block look small? Napa 1773. Each hold about 1 qt. I believe 18 micron rated and 30 psi BOV setting and high pressure GM bypass valve in block.. With the tighter filtration rating, I wanted to increase the surface area to mitigate the slower flow through the media.....then I doubled it. They operate in parallel. With running a thermostat, I have zero problems with oil temp. All 5/8" ID lines and Parker push-lock tubing. |
Anyone using a Wix 51515 or Wix 51622. I am running a marine power remote oil filter setup and the place I bought it from recommends Fram HP1. Not a Fan of Fram and both these cross to the HP1. Any advice is appreciated. Motor is a stock merc so I dont need anything too fancy.
Chris |
|
Originally Posted by the deep
(Post 4278226)
Doesn't change the fact that the information you provided has led me to upgrade my oil filter and for that I thank you .
|
Originally Posted by the deep
(Post 4278226)
Doesn't change the fact that the information you provided has led me to upgrade my oil filter and for that I thank you .
|
| All times are GMT -5. The time now is 12:51 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.