Bravo 3 clunks when engaging in gear
My 2003 SeaRay 340DA has twin 8.1s with Bravo 3s. When I engage the starboard side, it is silent and smooth. When I engage the port, there is a small "clunk" similar to an older alpha drive sounding when it engages. The noise is not loud, and there is no vibration. The RPMs are identical. Any suggestions on what I can look at before I remove the drive ?
Thanks |
Check the props and make sure they are both tight. The front one needs a big special wrench, the rear is 36 mm socket. They clunk when loose.
|
Gimble bearing.
|
Thanks, that will be the first issue I look at.
|
Thanks for your reply.
|
All times are GMT -5. The time now is 12:05 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.