Offshoreonly.com - Milling heads for compression

Page 2 of 2

Show 40 post(s) from this thread on one page

Offshoreonly.com (https://www.offshoreonly.com/forums/)

- General Q & A (https://www.offshoreonly.com/forums/general-q-20/)

- - Milling heads for compression (https://www.offshoreonly.com/forums/general-q/332734-milling-heads-compression.html)

Mr Maine

11-26-2015 08:46 AM

Yes, I will check the intake too

MILD THUNDER

11-26-2015 10:23 AM

The race series darts can be milled .070 down to 105cc and be within spec, as they have thicker decks. Mine were milled around that much, and my intakes fit fine.

The 308 Iron eagles, can be milled to 110CC and be within spec.

As cast, they have 121cc chambers.

This is from Dart's literature.

endeavor1

11-26-2015 10:31 AM

^^^^ Its like you've been reading up on these Dart Iron Eagles lately:coolcowboy:

ICDEDPPL

11-26-2015 01:11 PM

I like my large 345 Dart Iron Eagles. The more Eagle you have the more power you make., it`s a fact.

Mr Maine

11-26-2015 01:56 PM

Quote:

Originally Posted by ICDEDPPL (Post 4379938)

I like my large 345 Dart Iron Eagles. The more Eagle you have the more power you make., it`s a fact.

Are you running them on your cigarette?

All times are GMT -5. The time now is 08:31 AM.

Page 2 of 2

Show 40 post(s) from this thread on one page