Keep it simple
 

Thanks Iggy!
It is obvious that you are quite a bit more knowledgeable than the average reader. As I am sure you are aware, we have to keep it as simple as possible or we will lose the readers attention. You know us boaters, we usually are reading this stuff with a beer in our hand!
Sincerely
Dennis Moore

Thanks Panther!
 

Panther, I appreciate the feedback! I was a little afraid that the people on this forum are a little more knowledgeable about exhaust systems than the average reader and I am proven right!
Dennis

Re: Keep it simple
 

I thought we were supposed to read in the crapper:confused:

Have I been doing it wrong all these years:p

Re: Re: Keep it simple
 

your confuser isn't in the crapper? I thought that is why it was called the throne:D

That is a very informative article and I liked it. My only comment would be one to aid in ease of reading. Being more of your average type boater, I was distracted by the switching from "left side, right side" to port - starboard. The article would have been easier to follow using just "port bank" and "starboard bank" consistently.

BTW... where might I find this magazine? I ordered the BBC Marine book yesterday and am looking forward to that.

Good luck with the article,

BT :cool:

Thanks
 

Blue Thunder

Thanks for the input, I think you are right and I will change it.
www.familyandperformanceboating.com

Dennis Moore

Thanks Dennis,

You have any books on sterndrives?

BT :cool:

Dennis,

Good job on the Magazine. We finally got our subscription worked out, and were sent the issues we missed. Thanks for the help you gave my other 1/2 on the phone with our problem.

I would recommend this magazine to those that heve not read it.

Dennis
 

That will make A nice article in your magizine.I think anybody who will purchase that magizine will enjoy reading it.Very easy to follow .Now if you could tell us what manifolds work the best:D .
Dave

Crossover pipes...
 

Dennis,

I guess it's time to ask my wife for a subscription to that magazine for my birthday! I think the set of Merlin heads that I wanted are out of reach financially right now anyway. :(

Is there any way that I can get some of the back-issues of the magazine? I know that there were some interesting tech articles that I missed out on in the past.

My question: What effect would a crossover (or "H") pipe have on this situation? I have seen this setup on boats before, although not frequently. It has been used in automotive applications to boost low and mid-range torque. Would this help to alleviate the contiguous cylinder issue?