Offshoreonly.com
Page 2 of 2
1
2
Show 40 post(s) from this thread on one page

Offshoreonly.com (https://www.offshoreonly.com/forums/)
-   General Q & A (https://www.offshoreonly.com/forums/general-q-20/)
-   -   Valve springs, valves and push rods (https://www.offshoreonly.com/forums/general-q/336566-valve-springs-valves-push-rods.html)

Mr Maine 04-19-2016 09:58 PM
I just built bare dart heads. All apps are different but I went wit ferrea valves (super alloy exhaust and 6000 intake), 8205sp isky valves springs. Rocker studs were through dart but are AFR

Edit in: Valve stem clearance was set to .0015/.002 intake/exhaust and spring height at 1.86 inch

ezstriper 04-20-2016 07:41 AM
Originally Posted by MILD THUNDER (Post 4430343)
Penis, you'll need one of these .
Mild, that is the deal there, but I do a lot of my own as well, what I use is a heavy wire(coat hanger etc) cut and grind to the installed height using a outside mic and use the wire as a go/no go to set the height...works well...Rob

getrdunn 04-20-2016 07:56 AM
Originally Posted by ezstriper (Post 4430430)
Mild, that is the deal there, but I do a lot of my own as well, what I use is a heavy wire(coat hanger etc) cut and grind to the installed height using a outside mic and use the wire as a go/no go to set the height...works well...Rob
it will get the job done for sure just not as efficient. Kinda like tuning an engine without a wb o2. You can do without but sure nice to have. :bananalove:


All times are GMT -5. The time now is 03:00 AM.
Page 2 of 2
1
2
Show 40 post(s) from this thread on one page


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.