Where can I find this plastic fitting that goes in valve cover to flame arrestor.
 

Okay pic is attached. I bought a rubber one from Nappa and really doesn't fit well. I'm looking for the solid plastic one.
I have checked CP Performance, searched Bam's site with no luck, so anyone?

Merc # 97850T ELBOW, 90 Degree 97850 SS/ACT $3.80 $3.71 1

See #27 here:
http://www.mercruiserparts.com/bam/s...31912/4854/160

What about the red anodized aluminum ones used on HP500s. I've looked hi and low for another set of those

Thanks. I guess I did not drill down far enough on that site. Yahoooo have a good 4th everyone.

The hose nipples are welded/brazed or bolted/rivited to the air cleaner. The hose assembly is NLA from mercury, but the red anodized ends are available through any speed shop as is the braided hose cover.

https://www.summitracing.com/parts/fra-280006


Ryan

I was referring to the aluminum nipple that connects the hose to the valve cover.

Do you have a photo? Mine has the chrome breathers in the valve covers connected to the flame arrestor via the braided hose cover with red ends

This piece pulls out of that braided hose on the valve cover side. The fitting with a hose clamp just dresses it up over the top. I'll see if I can find a pic. My boats at the lake so I can't readily go get a pic.